🔩 Creality Original M6X 75mm Resistant Threads Review

I used this to replace a standard nozzle that wore out after god knows how many rolls of PLA had run through it. I can confirm this is for the CR10S Pro and it is very easy to install. Thanks to this nozzle I can see high quality prints again and with any luck I won't have to worry about changing nozzles for quite a while.

I recently bought another one of these because I recently found that this nozzle goes through several rolls of wood and CF filament. Not to mention the countless pounds of PLA and PETG that I missed. I'm doing this more as a proactive change as I need dimensional accuracy, but I'll clean the nozzle and test it under a microscope to see how it performs. However, for the price I paid and for all the prints I've mastered on both abrasive and non-abrasive media, it was worth it!

This nozzle fits the M6 x 75mm hot end (fine thread) used by Creality on the CR10s Pro. If you want to replace the Micro-Swiss nozzle, this is not the case. This is a replacement for the standard, unusually sized nozzle under the Micro Swiss brand. I switched nozzles and squeezed out 100mm of filament with no problems. Result 0.4mm +/- 0.02mm measured every 10mm along the extruded plastic. Some variance is to be expected due to the inconsistency of the cheap filament I'm using. A 0.4mm nozzle…