🔪 Precision Thin-Rip Tablesaw Jig Review

Great tool! Not only is it good on a table saw, it works great on a properly set up band saw, sawing thin strips of hard and soft wood for making guitar bindings as well as making intricate rosettes. Goodbye.

I bought this to use with my Craftsman table saw. Not the best option, but it will do for casual cutting work. It turns out that the slot on my table saw is narrower than the part of the jig that goes into the slot. As for this device, I don't know if it works or not.

I had two bad experiences with this device. Twice I seem to have pushed the ball bearing guide too hard against the material to break it and that stopped my table saw. The second time this happened I thought my motor had burned out but actually I threw a GFI breaker at the outlet. I also find the setting of the thin bandwidth a bit rough. There are markings, but no detents, say 1/16, 1/8, etc. Thus, perfect reproducibility from shot to shot is questionable. In my case, the jig fit into the slot