🪚 6 Piece Rotary Drill Saw Blades Set - Steel Saw Disc Wheel Cutting Blades with 1/8" Straight Shank Mandrel for Dremel Drills and Rotary Tools (Power Tools Excluded) Review

Photo shows blades and holder and all you get are blades what the heck do you do without a frigging holder, complete scam. How do I buy a blade holder if there is one?

Not as sharp as they should be. The screw that holds the saw blade in place is not tight enough. So if you're cutting at high speed, which you should be doing as the blades aren't very sharp, they tend to slip off the screw.

Excellent and powerful product. It kicks a bit when trying to start at slower speeds due to the long teeth on the blades, but it cuts very well and lasted much longer than I expected. And you get a few of these in different sizes, so that's great too!

It was useless when I used it to cut small plywood, the cutter's round blade is attached with a screw to a rod that goes into the drill bit, this screw can be locked in place, it just keeps falling out rendering it totally unusable, I've seen a few similar reviews but ignored them, my fault

They work and are cheaper than Dremel brands but the black coating came off as soon as I took them out of the box. They're good for a few uses depending on the project, but if you'll need this multiple times over the years I'd recommend spending the extra money and getting it direct from Dremel.

I carved a piece of dressing table from this pressed wood. They work fine, but because the part that goes into the drill is completely round, and when it gets stiff... it just stops spinning. It would be better if the part that goes in the drill was square or shaped other than round so the collar could grab and rotate it.