🚙 Rough Country 50" LED Light Bar Windshield Brackets for Jeep Wrangler JK 2007-2018, Light Not Included – 70504, Upper Windshield Mounts Review

Strong steel, super strong, perfect fit. What more can you ask for? Oh, enough room to run wires behind it so I can hook up the lights. Yes, that too. Just enough space. I used 14g wires and fabric wire to cover the wires. This kept the wires very flat next to each other and allowed me to route them down the A-pillar under the bracket and then into the gap around the hood. Front pillars that help protect against branches.

This purchase was a waste of time. This creates a lot of noise as the light bar is very low compared to other solutions. This forces a large volume of air under the lightbar and disrupts it by the airflow over the lightbar. If you have a soft top, the sound is unbearable. I was able to replace it with a competitor's product for the same price but more substantial and worth more. The problem with this product is that the top of the lightbar is flush with the top of the roof, which forces cutting

They are easy to install if you have the right tools. I used a set of torx bits, a 3/8 inch ratchet and an extension. Make sure the screws holding the lightbar in place are long enough to accommodate the thickness of these fasteners. When you put them on, leave them a little loose. This will help when installing the lightbar to the brackets. After everything is installed, cross-tighten the screws on the fasteners. Tighten one screw on each side. Don't tighten everything on one side and then the