SATA Arctic Case Fan Hub Review

Unveiling my unbiased review.Pros below: Solves the problem with the lack of connectors) Compact) Cons below: Minus only 1 - more designed to control 4pin fans, so consider

Sharing my candid impressions.Well made and high quality, and there are 2 types of fastening: 3M double-sided adhesive tape and magnets

Attention! If you connect 3-pin connectors to the device, then the fans will not be regulated, 4-pin PWM is needed. My motherboard can also regulate 3-pin, but they are not regulated through the hub. Only 4-pin. Has some pros: Works; Long wire; 2 types of fastening (3m adhesive tape and magnets); Different cons: When connecting 4-pin and 3-pin fans, only 4-pin PWM will be regulated. I thought it would be possible to regulate everything as a 3-pin, but in this case, everything starts spinning at

Some pros: - Speed ​​control - 10 places for coolers - Powered by SATA Got cons: - Not very strong magnets included - Shows rpm only if there is a fan connected to the first slot, in which for some reason the rpm is not regulated

Good hub for 4pin pwm fans, works as intended! It is advisable to connect fans that have the same operating speeds, because if the motherboard outputs a 50% PWM signal at a load, then for a fan with a maximum of 2022 revolutions, then 50% will be acceptable - 1000-1200 revolutions, and for a fan with a maximum of 1200 it will only be 500-600 rpm. You can have very noisy cooling because of this. at the processor, the fan will not work loudly at 600 rpm, and 5 case pieces will turn everything at…

In general, I don’t know if this is a design decision or a technical flaw, but the sockets themselves are arranged in such a way that the connector from the cooler goes into them completely. Thus, if you intend to remove it from there (the connector) for any reason, you will have to pull the wire, which can lead to a break or stupidly pull the wire out of the connector (the wire in the hand is the connector in the socket). Of course, I don't see this as a negative. I'm too lazy to take…

A brand whose name speaks for itself. Laconic design, sufficient number of connectors (x10) The only negative is that the connectors are deeply recessed; when you need to get the fan connector out of it, you will have to pull the wires very carefully and slightly swinging. In general, I definitely recommend purchasing it, especially for those who do not have enough connectors on their mother.