SEALIGHT Resistor Harness Adapter Canceller Review

Took less than a month. The connector from my wiring harness didn't stay in. Then after I fixed it, it kept flickering. I was driving home from work when one of them came out. The other came out a few days later. This is Chinese garbage.

Sealight LEDs are clearly of the highest quality and their customer service is exceptional. I had a problem with the headlights on one of our cars. One call to Sealight and not only did I not have to wait, they identified the problem and shipped the parts to me quickly and free of charge. In the meantime I have converted all of our vehicles to Sealight LEDs.

After installing Sealight H13/9008 bulbs in my 2010 Ford Explorer, I received a message on the dash telling me to check the headlight bulbs every time when I turned on the headlights. on the. I no longer get this message after installing this resistor kit. I had to remove the headlights from the car to install them and used small zip ties that were not included to organize the wiring.

Bought to fix flickering LED headlights on my Dodge 2500 Mega 08 Diesel and they worked great! The factory sockets for my HID bulbs were brittle due to the heat of the HID bulb, so I used a zip tie to secure the SEALIGHT harness connector to the new LED headlight bulb pigtail. The SEALIGHT wire harness to Dodge chassis wire harness was a perfect fit and was a well made product. Only a few zip ties were needed to insulate the hot segment of the wire harness.

If you have an older car that uses incandescent bulbs and decide to convert to LED lights like I did, you will need a kit of these (or similar regardless of the brand/company you buy). It was very easy to fit, the plugs are already connected and you just have to plug them in (hardest part is finding a place to mount them so they don't interfere with the headlight assembly. Problem I've had with new LED lights If you are also installing LED turn signals you will also need a capacitor for each…

What I didn't like is that when I bought the lights from Sea Light they said they fit my Dodge 2500 07 after they installed them had them flickering on and off After searching the internet I found this to be a common problem and I had to spend an additional 25.00 seconds with sea light on these resistors and removing the bulbs again to install them. The lighting connectors are also not attached to the factory wiring harness as there was absolutely no information on the resistors regarding their

The reason I bought this article was obviously that my new LED headlights stopped working after 4 months. They were recommended to me to solve the problem and they did. The new problem is that, as mentioned earlier, the resistors get very hot. I mean hot to the point where they started melting the casing around my headlights. So hot I couldn't touch them until they were cold, which was quite a while. I'm glad I let them run for half an hour with the case open and in sight because they…

My LED headlight manufacturer (Marsauto) told me I need them for my 2004 F150. After installing my new LED headlights I was unable to use my fog lights as it would activate the headlights on my headlights. So I ordered them (Marsauto refunded me the money) and installed them last night. The connector from the relay harness to the OEM connector didn't snap into place so I had to wrap tape around it to hold it together (both sides). Once both lights were connected to the relay harnesses, I…