While some might consider these overpriced, they do what is needed. My delivery included the self-tapping screws, but pilot holes were necessary. You will need the Dewalt right angle attachment for installation, unless you already have one. I installed with the lower edge of the clip 1.5" above the ceiling edge. The attachment and the clips were sent together by Prime in less than 2 days. My LED retrofits now fit snugly against the ceiling.

This is exactly what I needed. Measured an inch and a half in and do yourselves a favor and get a right angle drill attachment. Made my job super quick. Held the canned lights in place with no issues

These work fine and easy to install. I installed in cans on a 17 foot ceiling so I made a template to set the right height and to make sure they were directly opposite of each other. I used some flashing to make the template. I predrilled with a small bit and used a right angle drill.

I recently replaced my recessed lighting with Sunco Lighting 12 pack. However the old canisters that I have did not have any C hooks to insert the wire springs into to hold the new lights in place. This is what you need. They are individually package with one pair of C hooks and 2 screws. So here is the important part. you only have to go about a inch up into your metal canisters. I used a slightly smaller drill bit to make the pilot hole to make it easier to get the screw started. there are no

These worked out perfect for our replacement lights. The only difficult part was installing the screw - Maybe metal screws with a different end that cuts into metal would be more appropriate. Also, more choices for amount would be helpful so that you don't have to buy a excess amount (just a suggestion).

I purchased these clips to use on older recessed light housings that are not so equipped. There is another clip on the market that is a little more user-friendly; It locks into the bare edge of the housing to a preset position. However that clip will not work on retrofit housings that have a drywall flange. The clip I purchased here is universal and should work for all housings. I give it a 4-star rating because I am optimistic it will meet my needs for most applications.

Crappy little part but necessary to keep the the retrofit LED 5"/6" recessed lights in place.Difficult to install because you have to drill two screw holes in the old canister light fixture toattache the two clips.

Exactly like the ones sold at Home Depot but at half the cost! Installed these and fit as intended and so far no lights have fallen. I don’t expect them to either.

If you have the old style can lights and want to update to new LED lights you will need these. Previously tried securing the lights with different adhesives and was not successful; Installed these clips and now the lights are flush and perfect!

My can lights from 1977 did not have torsion spring bracket clips to enable the installation of new LED lights. These clips were exactly what I needed.