Sewer installation VORTEX KN-300 (300 W) Review

The plumber said that we would constantly call him for blockages if we did not install a sewer pump, since our equipment is below the entrance to the sewer. Obediently followed all his recommendations, bought a Whirlwind KN-300, though I did not expect that it would cost 7,000s. Installed by the same technician. Showed where to clean regularly to prevent breakdowns and prolong the life of the unit. For many years now there are no problems with the toilet.

He built a two-story house on his own and according to an amateur project. Toilets are located on the first and second floors. If it turns out that I screwed up with the slope of the sewer, then the result can be disastrous, at best, a smell will appear over time. Didn't experiment. Invested in pumping stations Whirlwind, in the amount of 2 pcs. The equipment is good, equipped with sensors against dry running and automatic modes of operation.

The pump is within specification. Works in automatic mode. There is a check valve to prevent water from returning. There is thermal protection. The pump is compact and fits easily into the space provided. Everything clearly works. For these few months, it hasn’t let me down — it works instantly, it doesn’t flow. Took for home.

The short cycles (2 - 3 sec. ) of turning on the pump during normal operation are not entirely clear. This is probably due to the small size of the housing or the location and short stroke of the inclusion float. In terms of reliability - let's see in operation. Has pros: Execution is excellent. The set is complete. There are various cuffs, adapters, clamps. The quality of the plastic case is excellent. Thickness is about 2.5 - 3 mm. Remembering the Sololift of the first versions, (now it can…

I was not ready to give such an amount for a sewer pump, so I dragged on with the purchase for a long time. But I had to clean up the consequences of the last flood myself, so I didn’t delay it any longer. I chose the average for the price, but its power and functionality are good. Good customer reviews. Connected under the sink and shower, cooling or water temperature control is required. Harsh chemicals should also not be used. I did the installation myself.

He hid the horizontal sewer pipe in a screed, apparently for this reason the water from the toilet began to leave badly. Dismantling, raising the toilet, it's all long and expensive. Advised to put a compact pressure pump. Whirlwind KN-300 came up for the price and good reviews about it. Takes up little space in a cramped bathroom. Turns on by itself. The non-return valve conducts water in only one direction, preventing it from being thrown back. After installation, the problems disappeared, I…

The sewerage system in our house is installed, but in the summer kitchen they continued to remove water from under the sink for a long time with the help of a garbage can. The whirlwind pumping station turned out to be most welcome. They ran pipes to the sink. Works in automatic mode. When the level reaches a critical level, pumping begins. In the absence of water, it turns off. It doesn't have a grinder.

Arranged a shower and sink at the dacha. Due to the narrow space, it was not possible to make a good slope of the fanina, the drains did not have time to leave, it was necessary to increase the outflow with a pump. In terms of dimensions, the Whirlwind fits perfectly into a narrow space, does not interfere, but pumps out perfectly. The operation is fully automatic, and thanks to the non-return valve, there is no return of wastewater. Noisy not to say that much, but audible.

In our country house, it was not possible to make a good slope at the sewerage on the way to the septic tank. Accordingly, sewage stagnated. Not enough bad outflow, more smells! In general, put this pump. In the manual to him useful information, the cat cried. It doesn't even say that the valve caps need to be removed. The installation went according to instructions from the Internet. It no longer smells, the water flows from three points immediately. Meanwhile, when the whole family is…

Installed the station for the first time. In general, the impressions are more positive. Power of 300 watts. What I like the most is that it is automatic. There is no need to constantly turn it on yourself. There is no overheating during operation. The motor is quite high quality with a copper winding. The main task of wastewater disposal is done with a bang.

I bought it to connect a washing machine in the basement, the sewerage is located 2.80m from the pump. The pump has time to pump out water behind the washing machine.

During a major overhaul, the apartment was redecorated. The kitchen has been a bit messed up. It was necessary to move the sink by 4 meters, and they were also going to connect the dishwasher. Plumbers advised the sewer pump Whirlwind KN-300 or something similar in terms of power and the number of inputs (there are three). It is intended, as I understand it, to solve problems with the drainage of sewage water, with the wrong slope of the pipes. On their advice, we bought another grease trap…

The pump was purchased for a private house. Installation and set-up went without problems, with it I had to buy additional structural and sealing elements. Works well, no damage was noted during the operation.

It has been working for a couple of weeks, I am satisfied, there were doubts, while everything is good, connect at least two inputs

Narrow tubes are installed in a private house. There were constant blockages in the sewers. The mistake that we inherited from the old owners was eliminated only with the help of the Whirlwind KN-300 pump. We chose this model because of the inlets. There are three of them, just for the washbasin, shower and washing machine. Installation is simple, but still entrusted it to a professional. I'll do something wrong again. Already fed up with cleaning pipes from traffic jams and limescale. There…

A bathhouse in the country house was built below the level of the septic tank. Since a shower cabin was installed there, the problem of pumping wastewater immediately arose. In the end, I found a fairly simple and inexpensive solution. I don’t pump 6 cubic meters per hour, so the throughput is enough with a margin. Pumps water up to 10 meters without much strain. In the winter, you have to empty the entire contents of the container, otherwise it will break in the cold.

With a new kitchen set, the sink had to be moved. From a different distance, due to the slope, the water did not go by gravity, problems began with its removal. I didn’t come up with anything better than to buy a sewer pump Whirlwind KN-300. I had no experience with such equipment before. We met along the way. Connected easily. It has been standing for almost a month, there is no smell. But loud as a dishwasher. In theory, it would be nice to put a grease trap right away. But so far so. I'll…

With the sewer pump, I did not increase the number of mistakes, and so I made too many of them. I just installed a toilet bowl from the lantern at one time far from the riser. For this reason, the water did not go into the sewer by gravity. Installation of the pump was entrusted to an experienced master. I did everything in my mind. I put the station right behind the toilet so that it was under supervision, and this location compensated for the unsuccessful slope. The second year is no problem.