Header banner
Revain logoHome Page
๐Ÿ”ง sierra international 18-2145 bravo shift cable for mercruiser logo

๐Ÿ”ง Sierra International 18-2145 Bravo Shift Cable for Mercruiser Review

3

ยท

Poor

Revainrating 2.5 out of 5ย ย 
Ratingย 
2.5
๐Ÿ”Œ Automotive Cables, ๐Ÿ› ๏ธ Replacement Parts

View on AmazonView on ะฏM

Media

(4)
img 1 attached to ๐Ÿ”ง Sierra International 18-2145 Bravo Shift Cable for Mercruiser
img 2 attached to ๐Ÿ”ง Sierra International 18-2145 Bravo Shift Cable for Mercruiser
img 3 attached to ๐Ÿ”ง Sierra International 18-2145 Bravo Shift Cable for Mercruiser
img 4 attached to ๐Ÿ”ง Sierra International 18-2145 Bravo Shift Cable for Mercruiser

Description of ๐Ÿ”ง Sierra International 18-2145 Bravo Shift Cable for Mercruiser

Designed for use in Mercruiser Bravo units. Comes with (1) Sierra 18-0318 Washer and (1) Nut (0.375-24). Interchangeable with Mallory 9-72156, GLM 21711, and Mercruiser Stern Drive 19297A3, 43432A2, 815471A3, 815471A5, 815471A6, and 865437A02. Check manufacturer recommendations to ensure a proper fit before purchasing. Each Sierra product meets or exceeds the original equipment part it replaces. Fit type: Universal Fit.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    0
  • 2
    1
  • 1
    1

Type of review

Revainrating 2 out of 5

Waste of Money on my review.

This shift cable is absolutely terrible. It was supposed to be easy to install, but instead it was a nightmare. I had to take my car to a mechanic who charged me even more for the installation.

Pros
  • None.
Cons
  • Difficult installation.

Revainrating 5 out of 5

Poor quality replacement cable

I have been a marine mechanic for over 15 years Gimbal bell housing, very thin and breaks off when pulled to seal the gasket with minimal torque. I strongly recommend using a different cable, it's not very good.

Pros
  • Before purchasing, check the manufacturer's recommendations to ensure a correct fit.
Cons
  • Not sure.

Revainrating 1 out of 5

Bad design. The device broke immediately.

Poor design. The faucet broke immediately. The cable is thicker which would help any boat that has had shifting problems in the past, but the thicker cable makes the fitting thinner. By the end of the thread, the wall is less than 1 mm. That might be fine with stainless steel, but definitely not good enough with brass. Mercrusier manufacture specifications call for 65 lb/in to tighten the nut, but the fitting broke at 35 lb/in. I ended up with a spare cable which I hand tightened and securedโ€ฆ

Pros
  • Interchangeable with Mallory 9-72156, GLM 21711 and Mercruiser Stern Drive 19297A3, 43432A2, 815471A3, 815471A5, 815471A6 and 865437A02
Cons
  • Security