Single Flood Bumper Mounting Brackets Review

The lamp was delivered quickly and in good condition. They work very well for our application, which illuminates presses and stamping machines inside to allow the operator to better monitor the structural integrity of the machines they are working on. I'll order them when the time comes.

Light not as shown. Ordered once and approved. The second time I ordered I got some really crappy ones that look similar. They weigh half as much and aren't as bright. Mounting brackets are completely different. Anyway, I went to install it and now I found that the wiring going to the light had exposed copper. Will have to return.

I bought these for my cargo trailer. I installed them as outdoor spotlights. When I tightened the side bolts slightly, they immediately loosened. If you look at it, the entire bolt and side cap are machined from a single piece of aluminum of the lowest quality known. A complete waste of money. I couldn't imagine them standing up to heavy off-road use, other than maybe the drive wheels.

Pleasant design and quality. Great for my road bike - had to tilt it down to be considerate of others, bike is more visible but not annoyingly bright. Can't comment on durability or water resistance yet. The specs seem correct, except that the amperage should be around 1.5 each. The carving was difficult for me, and I was in no hurry to remove it. Delivery and packaging are good. Great buy.

I am satisfied. I got what I paid for. However, the included steel nuts would not thread onto the threaded cast mount. I thought it was just rubber so I overdid it a bit and broke one of the studs. I had to use an 8mm die and drive in the remaining bolts. I used metal epoxy to fix a broken bolt. I give 4 stars because they ended up being the right size and amp for me. And look great.

Bright lights but definitely cheap. I bought them because they were cheap so it's on me. I'm definitely happy with the light they put out - they're very bright. However, on the first try I tried to install, the built-in mounting screw broke off before the nut was tightened. We "designed" a solution, but it was disappointing. The second did not survive the impact, which was minor but apparently knocked out the light. If you are looking for an inexpensive option then this is a good option. Just…

I have a Husqvarna garden tractor with integrated LED headlights. The original lamps are outdated and cost a fortune to replace. I'd bite the bullet and get a replacement, but OEM headlights don't last. I took a few of these and installed them behind the holes where the original bulbs go. They use more current, around 1A each, which is a lot more than the original smaller bulbs. The tractor has a smart switch to control everything including the headlights. I was worried they wouldn't handle the