🏍️ SKTYANTS 7 Inch Headlights Bucket: Enhance Your Harley Davidson Motorcycle's Look with a Sleek Black Housing Review

I used this bucket to install a 7" Daymaker LED headlight on a Honda Grom. I made a custom mount and didn't use the fork clamps that came with it. The bucket is perfect for the headlight. It was inconvenient to disassemble, install and reassemble, but there are no instructions. With this in mind, I have made a video guide at the address indicated in my attached photos. Build quality is pretty good, although I've noticed that after some use it needs a firmer coat of paint.

This is my second purchase of the same item, although my first from Revain. The delivery was amazingly fast! The product is good, but the headlight attached to the headlight when first purchased has lost its tolerance (due to vibration) and the headlight rotates minimally clockwise and counterclockwise in this section. The front part fits snugly into the rear part (cavity) without play or loss of tolerance. put a spotlight to fix the problem but I haven't tried it yet. . .Overall a good product

Used on 2007 Yamaha R6, fork bracket does not fit in fork tubes. I contacted the seller who responded quickly and asked if the other mount pictured would fit. The mount shown was the correct size for the fork and much better quality. I replied on 7/20/2020 asking if they would send the one pictured as a replacement and received no response by 7/27/2020. The project needs to move forward so I made a bracket modification to position the light. The bucket was well packaged with assembly…

The bucket itself is fine - there are no complaints about the build quality and fit, although there is nothing particularly special about it. I paired it with a 7 inch headlight from Cree who recommended this particular item and the headlight fitted nicely with a bit of blood and sweat. The instructions are absolutely awful and not worth the paper they are printed on. The whole assembly was trial and error. Fork clamps are useless. They're not even evenly concentric. Throw them in the trash and

It has three or four rings that need to be screwed to the body behind the headlight and on top of the LED headlight with tiny screws. Almost none of these fit very well and I found it extremely difficult to spend hours installing this fixture which was supposed to take 20 minutes. I highly recommend that an engineer can reverse engineer the way these LED lights fit into these buckets. Once installed they need to be fitted in minutes, they really look great. The fork clamps are terrible but I…

For the most part it was decent for the price but I definitely have some complaints. It took a little time to assemble because the instructions are so vague, but it wasn't hard to do. Just a trial and error time. The biggest downside was that the fork clamps are too small for my bike. I was already planning to buy some nicer ones but was hoping I could use them until I made this purchase. Unfortunately it isn't. But my bike isn't on the list of compatible bikes, so I kind of knew what I was…

Let's start by saying installing the bracket on my forks was a nightmare. Because they are universal I couldn't stand it, maybe some bending was needed but they didn't even come close and I spent about half the time bending them to actually fit my forks. The lacquer on the body and temples is very thin, I was very careful when bending but still managed to scratch them in many places and also used towels as a protective pad when bending the temples. I washed my bike after finally installing…

While the shovel is ok and certainly cheaper than the OEM buckets, the brackets supplied did not work. The curve of the piece of metal was not bent properly and the fasteners would not close to allow the screw to pass through the holes. I tried installing them on a 2018 MT 07 fork. Because the metal of these staples is very thick, I couldn't modify them. They would be very strong if the curvature was correct. I don't know if other braces have the same problem. And I had. The bucket came without