🔌 Complete 0 Ga 5000W Amplifier Install Wiring Kit | 0 Gauge Amp Kit with Installation Cables Review

When you strip plastic, copper looks more like 4 gauge! The plastic is thick like 0 to make you think it's really 0 gauge. So I advise against buying it if you really want 0 gauge. The clip slid straight in instead of fiddling with it a bit to get it onto the copper like it would have to if it were truly 0 gauge. CM. I love Amazon but they tried this product.

Go to any car audio store like Car Toys or Best Buy and see how much these cables cost. I bet you'll be back to Revain within minutes to make a purchase. do yourself a favor Save time you can't get back. You're only reading this review because you obviously need cables! Age!. Don't waste any more time and just buy them! They are worth it and will help you avoid the headache that you will surely get if you don't add them to your virtual shopping cart now!

Like many others, 1 positive connector is not included. You will need 3 connectors to connect to the battery and either side of the fuse. You will need a fourth connector which is pictured but not included and should be used to connect to the amplifier. Nobody sells the connector separately, so you'll have to buy another kit to get one. RCA and cable protectors are useless, so they shouldn't have been included in the kit at all. I couldn't complete the installation due to a simple thing e.g…

It appeared and contained what they drew. However, it does not contain a sufficient number of fasteners. You will need one red spade lug for the battery positive terminal, two for the fuse and one for the amp side (depending on the project). . I used a heat gun so execution was not a problem. I haven't turned on the system yet, so I'll have to update that later.

Exactly what you expect. Includes all the parts needed for a complete amp installation, but I recommend purchasing an additional 0 gauge ring terminal kit and an additional fuse box. Technically, only one fuse box is required next to the battery on the power cord, but it's also best to place it just before connecting power to the amp. By the way, this is NOT OFC (copper wire) but CCA (aluminum wire). This is normal for 90% of people (including me). However, if you're using anything over 2-3…

Not bad for the money. It is CCA (Copper Clad Aluminum), not OFC (Oxygen Free Copper). OFC is the best choice but more expensive. The connector is a little wobbly, but it does the job. The fuse holder works, but I recommend zipping the lid closed for security. The cinch cable is scrap, I had to replace it because my fuel pump was constantly humming through the amp. I have a high volume race fuel pump that probably doesn't help. But this is a very inexpensive kit that will suit most people who…