FLIBEN 15-72548 599-007 9378815 HVAC Control Module for Cadillac/Chevrolet/GMC Models: Efficient Equipment Heating and Air Conditioning Control Panel Review

This panel is as described, fits perfectly, plug and play, solves a problem I've had for a while with faucet doors not working (usual GM issue), fast delivery and excellent quality, i am ordering another one for my other escalade with the same problem.

I was pissed off I took off the front panel, took off the old one, put on the new one and cut it off, it blew hard but when I put it on the heating side worked not at all, so I had to take it off and put the old one back on. Then the heat started blowing again.

. I was pissed as hell. I removed the front instrument panel, removed the old one, put the new one on, cut it open, it blew hard but when I put it on heat, the heat side didn't work at all so I had to take it off and put the old one back. Then the heat started blowing again.

The product is easy to install, does not heat the car like the previous temperature control module, and the air conditioning is always on. But I'm stuck with this as my return window has closed and I should like it. I'll be spending extra money on Dorman just so I know it works, thought it would save me money but I think I've just spent twice as much.

Works well. Before installing, disconnect the negative pole of the battery, remove the defective climate control, install a new climate control. Connect the negative pole to the battery. To calibrate, turn the ignition key two clicks and do not start the engine. The actuators calibrate themselves, this may take a few minutes. You can hear the drives themselves being set up.

Excellent replacement for original quality. The only reason for the 4 stars is that I had 2 minor inconveniences, but that might be a bigger issue for others. Issue 1) The blended door actuator may need to be recalibrated or manually adjusted. I just adjusted mine manually. It hurts, but if you remove the ashtray assembly it's a little easier to get to. Simply remove the drive cover to reposition the gears so the gauge is within the lines. It's easiest to set up a broadcast when it's offline…