🚗 StaiBC 12V Electric Fuel Pump Diesel Petrol 12 Volt - Efficient and Reliable Fuel Transfer Solution Review

Works well. Installed it in my truck and overflow tank. A bit noisy but I want to know when it's running. So I'm kind of a security nut.

replaced the vacuum pump with an electric one on my lawnmower, works fine but delivers too much fuel at idle causing the engine to run rough.

This little pump has helped me drain about 20 gallons of fuel/oil mixture from my boat's tank. The little pump worked without fuss. Very well made and a good product for my application

Bought for the primary pump on an old diesel tractor. The bellows at the end are leaking and can no longer be used. I won't be ordering again, and while it worked well, it was pretty quick, which seems unacceptable to me.

Fixed a frozen engine issue on my Kubota 1870. Plug fits and works great. At the same time I replaced 2 filters and drained the water from the tank. Bit of Pain fixed the issue of him dying after warming up.

This pump is used on our 41ft diesel sailboat. We have two racors, a 50hp beta diesel engine, diesel generator and diesel heater for cold water sailing. This makes priming very easy with a switch and this pump. I ordered it from Revain and received it within two days. easy installation. Easier than using a manual motor pump

Here's a handy tip if you need to replace the fuel pump on a late 1980's Ford New Holland 3 cylinder diesel tractor (eg: LGT 14D). electric pump (not part of the injection system) above). Dealer Replacement +/- $165.00. This is a 2 wire 12 volt pump that supplies the engine with enough fuel. It even bolts directly to existing frame holes on the original pump. Hope this information helps.

Bought as a desperate replacement for the diesel 430 John Deere. The JD part was over $200 so it seemed like an easy gamble. It's physically a little longer than a standard JD pump, but it fits and the bracket and screw holes match up perfectly. The electrical connector even connects to the tractor's wiring harness, although it appears to be manufactured to very tight tolerances. After still having problems I cut off the connectors and soldered new ones which solved the problem. I've got about…