🖨️ SUNLU Marble Printer Filament: Enhance Your 3D Prints with Stunning Marble Patterns Review

I bought a roll of this material and it printed well for the first two days. After two days I started under-extruding which eventually resulted in a clogged nozzle. I've tried increasing the temperature and also tested the settings other reviewers have posted here on Revain, but I kept getting jams no matter what I did. I suspected the thread was very hygroscopic, so I measured the roll on my postal scale, wrote down the results, and dried it in kibble overnight. When I weighed the reel the…

I gave this filament 5 stars because of the way it prints and the end result of your print. I have used this filament to make flower vases in Cura spiral vase mode with to make some print settings. So far, so good. They even manage to retain water without interior waterproofing (I use shellac spray). The only downside is that the thread doesn't change color as often as Revain says. The first 2 vases and the drink holder used over 22 meters and the color has not changed yet. You may have to…

I liked the colors I got from the prints with this product. I've had a few successful prints that have bounced, the color is very warm and silky, it glosses well and shines beautifully on the glass surface. However, the number of errors and headaches I've had printing this stuff makes it such that I will never buy it again and I cannot recommend it to others. The adhesion of layers with this filament is very bad. I've found my prints often fail due to delamination until I get the temperature…