🔌 Complete 700Pcs Automotive Electrical Wire Connectors Kit - 2.8mm 2 3 4 6 9 Pin – Includes Pin Header Crimp Wire Terminals & 30 Kits of 4mm Car Motorcycle Bullet Terminal Wire Review

small metal parts holding the cable flimsy when you disconnect the plugs the cables fall out even I have stopped using it my standard plugs lying around work better and more reliable

Absolutely suitable for my use. The plastic feels solid, the connectors fit well into the case, and the case snaps in place nicely. I have an inexpensive crimping tool and I install connectors like a pro. OK, professional handyman

Purchased to redesign wiring harnesses based on Chinese motorcycle components. Works well, fits standard plugs. Due to the very thin metal on the terminals, crimping correctly is a bit more difficult, but doable.

I found it acceptable for the price. What could be improved is the female part which was a bit too flexible but I left the solder on so it will most likely work wherever these parts are needed. This kit is good value but I expected exactly what I got.

Great connectors! Very durable and well built. Sturdy and reliable with quality pins. Terminate the wire with my custom crimping tool, insert the pins into the terminals and you're good to go. This allowed custom connections on my John Deere for some additional main dash switches. Disabling it quickly will allow me to remove my dashes in the future.

Very good set, works like a charm and helps me fix bad motorcycle and quad wiring harnesses. A large thickness value seems to work correctly. In the review, I was asked to rate the quality of the weather protection. These connectors are not weatherproof, they are designed to be placed in plastic or under gas tanks, under seats etc. Anyone who wants a weather-resistant, quality connector wants "Pack" connectors to have a great time rewiring 👍 😎

You will run into a couple of problems when using these connectors: 1. According to others the largest wire they will fit is 16 gauge but even that seems like a stretch to me. 2. After installing the connector's spade tabs, you must carefully align the pins so that the connector aligns and connects. Depending on use, they can then be knocked out of alignment and later damaged. 3. The metal connectors do not match exactly. If this is a connection that you connect and disconnect on any frequency,

The terminal/pin sockets in these plastic connectors do not have the same tolerances as OEM connectors. This results in the terminals/pins in the connectors being very loose and causing problems mating the male and female ends together. The supplied clamps/pins are not as thick as the OEM clamps and are quite fragile. This, combined with the loose fit in the connector, makes it very difficult to mate the connectors without bending the pin. I even tried using the terminals myself in the OEM…