🌊 Tailonz Water Trap Compressor with Pneumatic Regulator Review

This regulator cup ripped off with pressure on the first squeeze. I had teflon tape on the threads when it broke. I removed the teflon tape and pressed again. This time my 30 gallon tank only managed to gain 75 pounds instead of the 125 limit. When I took off the shell the third time, I took a closer look and saw that the shell was warped along with the main body! Don't buy Chinese junk! Looks like a runaway! Just the opposite. First and last customer! There is no thread in the picture! This is

I bought this to add to my little pancake compressor. The compressor already has its own outlet pressure regulator so it acts as a backup if something goes wrong with it. I connected it between the pressure outlet port and the air hose to trap moisture and contaminants that would otherwise get into my air tools. The manual that comes with the controller is usually poorly translated from Chinese. They don't say how to assemble it, but it was easy to figure out that the air knife goes in the…

I didn't want to spend $80 on an Iwata brand regulator/water separator so I went with this one. Using the included thread sealing tape I installed the included pressure gauge and two 1/4" NPT nipples. I connected my hoses and connected them to the air compressor. So far the controller is working great. It holds a good consistent pressure while I airbrush it I have tested it from 10psi to 35psi for airbrushing no problem I left the airbrush plugged in overnight with a full air tank and came back