🔌 Tetra-Teknica MotoBasics Series RHS-01 12V Ring Terminal Harness with Black Fused 2-Pin Quick Disconnect Plug, 2 Feet, 16 Gauge Copper Wire, 10A Fuse, 2 Per Pack" - Improved for SEO: "Tetra-Teknica MotoBasics 12V Ring Terminal Harness with Black Fused Quick Disconnect Plug - 2ft, 16G Copper Wire, 10A Fuse (2 Pack) Review

I found that both of the 10Amp fuses that came with the wiring harness were blown. They burned out when power was applied. 12 volt DC quad battery. No load, no additional wiring. I didn't install any equipment, just a wiring harness. Connected directly to the battery. The internal fuse link turned out to be very thin. I replaced them with American fuses. 10 amps. Worked beautifully. It's still worth it. Advice for those who might need it. Danger.

I used these to connect an old Jeep battery so I could easily connect a charger to it if needed. I chose this one because it has a built in fuse, is a good length and comes in a 2 pack. I am very happy with the quality and it worked well for my application. The only thing I don't like is that it's very stiff compared to the similar ones I've gotten from Shumaker and Battery Tender. Pros: - Quality - Length - Integrated fuse - 2 packs Cons: - Rigid

I bought this off label to charge a car battery, instead I used it to "convert" my Power Wheel children's toy rides from 6v to 12v. Adequate for small motors , and it comes with a built in fuse box (although I had to "upgrade" the fuse to 20A). Car charger with protection circuit instead of the included chargers: This is faster and easier on the battery, whether you use it with 6V or 12V.

I installed them on my quads and snowmobiles to use the charger. In the winter months I won't be using the machine very often and the batteries will be very expensive. Most quadricycles and snowmobiles are like new cars because there is very little space under the hood and the battery is difficult to access. After taking the time to install one of these braids, you can easily connect the charger. Pros: Heavy gauge wire with built in fuse. (Twice the weight of others) Pigtail length is perfect…

I need to keep my boat's various 12v batteries charged over the winter, but I didn't want to spend a fortune on separate charging systems for each battery. Even though I have one charger that can charge them all, I can still only charge one at a time. Disconnecting/reconnecting the charging leads to each battery in turn was a problem for months - these harnesses fixed it. What. I installed one for each battery so I could just unplug one battery and plug in the next. I no longer have to fiddle…

These Quick Connect devices make charging your battery much easier. A much better solution than the alligator clips that are usually attached to the battery posts. The only recommendation I can make is to include a set of 2 5/16" x 1" bolts, 2 nuts, 4 washers and 2 lock washers so that the quick disconnect can be immediately attached to the battery posts and not the running equipment. to keep. I have 3 12v batteries, all quick connect. They are all interchangeable with my emergency generator…

I bought this to complete a simpler shore loading system for my boat. The kit works in any situation where you need to regularly charge or maintain 12 volt batteries. This was necessary to make it easier to load the boat on shore. I'm tired of crawling under the dash to attach alligator clips to charge the batteries. These ring terminals were perfect. They fit right into the battery terminals and the SAE connectors make it easy to connect to either my solar panel or ground charger. The charging