🔦 DWVO Headlight Assembly for 2005-2006 Tundra Double/Crew Cab & 2005-2007 Sequoia Pickup - Headlamp Replacement Pair with Chrome Housing and Amber Reflector Review

I don't know what the other reviewers said the complex installation took literally less than 15 minutes per bulb on 06 DC including removing the old bulbs and fitting in Lightbulbs, very abrupt and dry if you have common sense.

Beautiful clear headlights. Easy to install on 2007 Toyota Sequoia. The only annoying thing is that the paper stickers they put on the lantern holes when delivered fell into the lanterns. Maybe because of the rubber mount. Maybe there is a better way to close the hole during shipping.

The headlights looked really good out of the box. Installation didn't take long, suitable for the aftermarket. Now the problem. We had rain overnight and the passenger side side light was already leaking and leaking moisture as shown in the photos. These lights were installed for ONLY 1 WEEK. I dare say that the quality control during their assembly is nil. This should never happen right out of the box. I will return them hopefully they will be replaced or refunded.

Definitely not an easy install. I figured it wouldn't just fit as they are pretty cheap for the price but took a lot of extra time to install. The top holes that were supposed to slide on the round rail were too small and had to be drilled to fit. Due to the upper attachment, the attachment points were far away. Approximately 1/2-3/4 inch. High in the lower mounting area when the upper one was attached. Had to heat the top mount and slowly pull down/start then tighten the bottom mount bolts to…

They match my 2006 double cab Tundra perfectly. My truck looks almost new now. I can't get over how much they improved the look of my truck. I also swapped out the fog lights, and now my silvery tundra sparkles so much it made me salivate at first sight. It took me 30 minutes to remove the old headlights and replace them with new ones. My headlights are very bright again! When my truck was new people thought my headlights were on when they dimmed. It's happening again with these crystal clear…

Adhesive threads are stuck to the lens of one of the headlights. The top hole had to be widened 1/4" to fit the headlights. Some of the stitching on the markers was poor quality. (Obviously bad glue) The headlight beam adjustment screw/gear is flush with the back of the headlight. That means that the light cannot be adjusted with a #2 Phillips head like the original lights, so the side marker lights had to be removed so I could use a 10mm wrench to make adjustments, correct adjustment was…

I bought these headlights because mine broke and I thought the black housing would be cool. Easy enough right? When they receive them they appear to have been picked up by toddlers and look like total junk. They leak and fog up with the slightest bit of rain, which can be corrected with some silicone but isn't necessary for a quality product. I contacted the company and it was easy to work with them. I received a second set that was worse than the first set. I sealed them with silicone prior to