🔌 TronicsPros LED Connector Cable - 4 Pin RGB LED Tape, Ribbon & Controller Connector - 6in Length (10pcs) Review

Wire gauge fits. The pins between the pins are too short and do not provide a reliable and durable connection. Not the best choice.

I need these to connect my LED strips to a box that allows me to control the LEDs from my Hue system and they have worked great. Very reliable.

These are good cables but the color codes are wrong for addressable RGB. For ARGB you need black, any, green, red), but you get black, green, red, blue. I ended up wrapping them in heat shrink tubing because I really didn't need colored wires in my case when all the other wires were black. I deducted a point for not being black, but you can't beat the price and the quality is good. It was close.

This connection cable is suitable for RGB LED strips. Good for DIY projects. For example, you can solder a 4 core cable to 4 copper pins on RGB LED strip to connect them, then you can use this jumper cable as a birdie to connect RGB LED strip to RGB LED controller ; You can also connect the cable to the RGB LED controller, which already has a female interface for connecting 4-wire cables, etc.

I'm tired of soldering wires to pins. Soldering on the wires or just using shrink wrap will work and it's much easier to install and extend the wiring. I've found that cutting the light strips by soldering is really the only way they stay connected, so I use this for when you need to cut the strip because all those fancy simple connectors don't seem to work after a few months , even when used solid objects such as cabinets and blankets.

Looking for a 4-wire solution to get contacts on one end and bare wires on the other? It does the job. Native female plug, but quickly converts to male plugs with a bottom bending block. After the installation is complete, some of them are fixed better than others. For most of them, the connection was strong. But I had to, that I had to replace. after I soldered the wiring. because they just couldn't form a strong bond. It seemed to them that they would not go to the end, although they were…

If it wasn't for the price I would give it 2 stars. They plug into the LED headers on newer motherboards. My plan was to use them and make my own LED strips to connect them together. The problem is that the included 4 pin male/male jumper is not big enough. Because of the small size, if you connect 2 cables together, the slightest movement will cause them to break. This requires the use of electrical tape or similar to ensure the connections are held in place with even the slightest movement…