🛠️ Tulead Machinist 100X70mm Engineer Woodworking: Precision and Versatility Combined Review

Good for 90 degree miter saws. Works on my table saw too. Another time I used it to make sure the little box was level during assembly.

The unsurpassed quality of these economical engineering squares. The inner and outer edges have been beveled to avoid sharp edges. The relief of the groove is clean. Both the inner and outer surfaces are perpendicularly oriented.

Like. I have several now. I use it to set up table and shop saws and get my bandsaw blades perfectly perpendicular to the table for trimming. They are strong and well suited for leveling inside corners in small bonded areas.

There are no burrs on the fittings like others. It is exactly as advertised and works well for me with flat materials like basswood and styrene. Modelers should benefit from having this in their toolbox.

Bought this to tidy up my new miter saw. I tested it on the large squares I have and it turned out to be correct. The new saw was set up perfectly at the factory, so I would like to say that everything is fine. As already mentioned, it has a beveled blade. Good for angling edges, but probably not ideal for marking things.

I have to say that I am not as happy with this product as I had hoped. But it's square on the outside. The inner one cannot be used as 2 ridges remain on the inner edges of the corner. Marks and small dents. I can live with that, but the question is whether these dents were made before this square was cut or after.

I bought a set for general use and/or small welders, certainly didn't expect them to be the same as my control square. But damn it was crap. There were ridges and protrusions on both edges of the inner corner relief. Couldn't even insert the part before it was hanging. It's bad enough that I've started grinding it to acceptable accuracy first with a flippin cut-off wheel and then with a diamond lapping wheel. The outside "squareness" was over 0.006" on a 3" long leg lol. For a laugh, I used a…

I have to say that I am not as satisfied with this product as I had hoped. But it's square on the outside. The inner one cannot be used as 2 ridges remain on the inner edges of the corner. Marks and small dents. I can live with that, but the question is whether these dents were made before this square was cut or after.

I needed this special square for leather work. When assembling items like wallets and phone cases, I need to glue multiple layers together, and I need to align them with at least two edges when placing and laying out the pieces. This little square works perfectly and is the right size for the job without being overbearing. After receiving mine I wiped them down with hot soapy water to remove the manufacturing and shipping oil and then applied a very thin coat of foot oil to make them skin…