Header banner
Revain logoHome Page
inch grommet drawing organizer by uxcell logo

Inch Grommet Drawing Organizer by Uxcell Review

3

·

Average

Revainrating 3.5 out of 5  
Rating 
3.7
🔩 Grommets, 🔩 Industrial Hardware

View on AmazonView on ЯM

Media

(4)
img 1 attached to Inch Grommet Drawing Organizer by Uxcell
img 2 attached to Inch Grommet Drawing Organizer by Uxcell
img 3 attached to Inch Grommet Drawing Organizer by Uxcell
img 4 attached to Inch Grommet Drawing Organizer by Uxcell

Description of Inch Grommet Drawing Organizer by Uxcell

[FIT FOR] - 2" (50mm) hole diameter. [TOTAL SIZE] - 2.20" (56mm) max diameter, 0.55" (14mm) high. [MATERIAL] - Made of zinc alloy, electroplating finish which makes their appearance more elegant, anti-corrosion, good wear resistance. [EASY INSTALLATION] - Simply drill or cut a hole through the surface and insert the grommet into the hole.Note: When selecting the threading box, make sure that the size of the reserved hole on your desktop is slightly larger than the applicable hole diameter 0.5-1.5mm provided by us. [WIDE USE] - Organize wires and cables on office equipment, computer components, entertainment systems effectively.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    1

Type of review

Revainrating 5 out of 5

Looks good for industrial equipment

Looks good. I bought to replace a missing plastic cover and it looks much better and doesn't scratch. It's 2 3/8" and was a bit tight so I used a rubber mallet to set it flush with the desktop.

Pros
  • Best
Cons
  • Ugly packaging

Revainrating 5 out of 5

just under 2 3/8 inches

I really appreciate the feedback that they are slightly smaller than the advertised size. I have a table that I lost the stakes on and when I measured they were 2 5/16 and the 2 3/8 stakes fit perfectly.

Pros
  • All right!
Cons
  • Expensive

Revainrating 1 out of 5

Will damage wood worktop

Bought this cord cover to replace a plastic grommet that wasn't holding the cords in place. Although this jack works well, the finish quality is poor. The underside of the jack is rough and unfinished with no burrs, which I learned the hard way. I ended up turning the sleeve after inserting it into a 3 1/8" diameter hole in my table. After removing the bushing, I noticed a fairly deep scratch on my table caused by the bushing due to the rough underside of the left bush.

Pros
  • Easy to use
Cons
  • Quick start guide