🚗 Upgraded VIPMOTOZ Full LED License Plate Light Assembly for Honda Accord Sedan Odyssey Pilot Civic & Acura MDX TSX TL ILX RDX RL – 6000K Diamond White, Pack of 2 Review

Really makes your license plate/license plate frame stand out at night. Super bright white light. Installation took 2 minutes. FYI, that was for my 2017 Honda Accord Sport.

Very bright! In addition, the extended cable connector provides more space to work, better than the OEM part. One of the two stopped working within 2 months.

Installed on my 08' Acura TL. Simple plug and play. Perfect fit and much brighter than the LED bulbs I've had before. Let's see how long this lasts as some reviews say they stop working after a few months :-(

I got pulled over for the blue light on my license plate. I had to turn it off. When I went to check what kind of light I needed, both the lid and the clamp broke. It had everything I needed in one frame. it was easy to replace, works great, one small price instead of three. light minimum. And I got 2 for the price of just one bulb. Even if it falls out in a few months, it's still a good deal for a 3-into-1-2 (2005 Honda Accord) package.

Super bright. To the point that it's abnormal and draws a lot of attention to the car. It can be good or bad, depending on your preference. My only concern is that the wire connecting to the car and the light itself will be dangling and only held in place by a small electrical wire that appears to have a very thin solder joint, potentially leading to breakage by the user . Part during installation or failure in the near future. The only reason for a star rating is the build quality.

So had high hopes for these. The quality seems ok, the price is reasonable, the light output is not bad. However, the tab on the right side just wouldn't snap no matter what I did. I took a closer look and noticed that they have a straight bevel compared to the OEM concave prosthesis (pictured above). I ordered two pairs and each does the same thing. It clicks like it should, but the tab just keeps slipping out. And I checked, it says it fits my 2007 Honda Accord.

Replacing the entire fixture is no more difficult than replacing a lightbulb as replacing the lightbulb requires removing the entire assembly anyway. There are no instructions with this product, but it is easy to find out, or you can find and follow lamp replacement tutorials on YouTube. You have to apply quite a bit of pressure by tugging at the back for it to snap into place, but once it's in, the difference becomes day and night. The lighting is almost too bright, to the point where I had to

I can't tell you how easy it is to install these LED lights. Plug and play that fit perfectly and are very bright! After removing the 5 clips holding the trunk trim simply disconnect the 2 license plate light wire adapters and remove the trim on the outside of the trunk over the license plate. Start at the ends of the trim to loosen and remove. Then simply squeeze the tabs on each side of the light outside and inside and pull out. Take your new LED light and feed the cable through the light…