🔌 High-Quality Pre-Wired Connector for VNDEFUL T10 W5W 194 LED Light Bulbs: 10 Pcs Car, Truck, Motorbike Socket Review

I use them to replace old ones on a car being repaired. They are of good quality and have enough wiring to replace damaged parts.

Used to convert low voltage garden lights, great fun to work with. Just don't pull too hard on the wires. This breaks the internal connection.

I used these and some LEDs in the overhead console of my 2005 Ford Excursion. I drilled and attached them to the plant. They will be crushed if you handle them too roughly during installation.

This is the best way to convert classic automotive dash lights into more modern wedge base lamps. Higher quality and more reliable LEDs that fit well in I-Strummer clusters.

Not bought for the car. My non-critical use was fine. I had to pinch the soft copper contacts inside the cartridge to make contact with the bulb. The best sockets have stiffer springy contacts.

Everything is fine. A little problem; It turned out that some of the plugs were not aligned as required for the bulb installation. But I quickly found that the wires could simply slide out of the socket, rotate them to the desired position, and then plug them back in. Easy!

Turned out to be a standard 194 automotive bulb socket that fits into the bulb housing with a quarter turn. But they are too small to fit in the housing of an American car, a trailer side marker or a tractor taillight housing. Very bad. I had to replace a couple of rusted sockets and they won't work.

It's cheap and all 10 have misaligned outlets. Originally the cartridge contained a T10 bulb. Tried using a small screwdriver to adjust the angle of the socket pins on the bottom of the socket so the T10 bulb fits properly. Broke a lightbulb and socket trying to fit a lightbulb into the socket. Another problem is that it will be very difficult to remove the bulb once you have inserted it into the socket. The body of the holder is made of soft rubber materials that make it difficult to install…