🔧 WAL-PPN2-R OEM Replacement Fuel Pump with Pressure Regulator & Strainer - Perfect Fit for Victory Kingpin Deluxe/Premium/Tour/8 Ball/FLMS/SMB/CH (2004-2012) Review

It should fit right on top of my fuel pump. It wasn't even close. The filters were of very good quality as was the pump but it didn't work for me as I had to send it back.

I would give 4 to 5 stars if they offered a grommet/gasket for mounting the pressure regulator and more helpful tech support (which really sucks). SURE BUY THE RUBBER GASKET THAT COMES WITH THE PRESSURE REGULATOR OR TAKE IT OFF THE SECOND TIME AND GET PISS.

You get what you pay for. No instructions/information. Screens are 10% smaller than original screens. The most important part you need when replacing a pump is the gasket in the pump assembly. You can't buy it separately, not even from Polaris. I ended up sending this and my existing fuel pump to the well known Vic Shop in Iowa for restoration. They could only use the pump. Sending it in for repair won't save you money this way unless all your gaskets are in tip-top shape.

If you need a fuel pump this is a great alternative to replacing the entire assembly that Victory will sell you for over $500. 9 times out of 10, the rubber bushing between the pump and housing is leaking (resulting in a loss of fuel pressure). This is due to the quick clamp they use to hold the two pieces together. As the thin rubber coating between the pump and yoke wears down over time, the pump will loosen somewhat and pull away from the tight joint, which will not seal well and will result