WindyNation LIN MBRK 01 Actuator Mounting Brackets: Secure and Versatile Installation Solution Review

This selection of brackets was linked from the page of a drive I bought. The pins that came with this mount don't fit the holes on the actuator I bought, I had to use 1/4" screws. It's fine, but if you link products together, we should make sure they work together, right?

Ideal for a boat hatch. I installed them with an Everest Parts 24 inch drive. I had to drill the mounting holes in the actuator a bit wider to get the mounting pins through, but it was easy to do. Both brackets were supplied with cotter pins as shown. Not black/dark grey, but in the photos they appear in plain silver steel.

I purchased 3 WindyRiver actuators and 3 sets of mounting brackets for them in the same Revain order. However, when they arrived I found that the pins in the mounting pins were .315" and the holes on the actuators were .31". Close but not suitable. I deliberately bought both from the same company assuming they would go together. One of the drives I bought with mounting brackets. They fit well, the pins are obviously a slightly different diameter. If you look very closely you can find the…