🔧 2 Inch Matched Milling Woodworking Yakamoz Review

Double shank has blades that are not 1/4 the same! Not even close! One blade is 1/4, two is more than about 1/32 of the gap, and that's too much! Joint's end results are useless. Buy somewhere else! I wish I had tried and gotten it back in time. Too late. I used an extra shim (must be purchased) to evenly space and adjust. It has cost me more time than buying higher quality shafts.

I am not satisfied with the quality of these bits. I went cheap and now I have to spend more for a better set. All right, lesson learned. They made horrible cuts with huge incisions and uneven depth. I used a router table and took every precaution to ensure good cuts, but the results were unusable. Since these types of bits are pretty much exclusive to joinery, I'd recommend spending a little more for quality.

I made 14 shaker doors out of it. As a result, the fit between the rails/styles is too loose. I wish I had spent more than $$$ and bought a set that gave better results. I used a router table to cut 3/4" poplar boards. I'm not sure if tongue or spring is to blame here, but one of them definitely doesn't work (like others have said). I ended up using the doors made these parts, but the money I saved on these parts was wasted on the time it took to align everything and fasten it properly, and…