Yonico 14107Q Degree Double Carbide Review

This cutter was a waste of money. The first time I used it I set the depth to 1/4" and used it on Red Cedar. This burned the wood and made it very difficult to move the router while I was routing. It seemed very tedious. I adjusted the depth to cut less deep and it still burned and still had trouble cutting.The 90 degree side behaved the same but didn't burn it just seemed very weak quality bit should go.

This is by far the worst (stupid?) cutter I have ever bought. I've been carving for over 15 years. When I tried to have the router cut into the wood, it never entered the wood! I kept looking at the base of the router and thought there was something on it to keep the router from cutting into the wood. But that was because the router bit was so dumb! Unbelievable! He only burned wood (see photo). When I took it out of the box it was a shiny new piece. Maybe that was it. Yonico was the lowest…

I was hesitant to buy this bit because of the 1 star reviews. I bit the bullet and took a chance. The bit comes very well packaged, not just a small zip bag. I cut at a 60 degree angle. side on a piece of pine/spruce and the result was clean. The carving edges were sharp and needed no additional cleaning. The edges still seem sharp, but only time will tell how well/long this attachment will hold up. Please note that the 1 star reviews are from 2015 and all relatively recent reviews say this is…