Review on ANYCUBIC FEP Photon Mono Pieces by Lance Foster

For those who "cry" because they don't have enough instructions? Find out! On the back of the box you will find basic instructions on what to do. You don't need a neurosurgeon for that. Hopefully not pre-cut! You need to make them yourself after aligning everything correctly. A simple trick: after removing the old foil, place it on the table and attach it to the two clips together. Align the film as evenly as possible and I hope you use a good allen wrench. Slide the assembly slightly off the edge of the table and use the hex wrench to make the first hole in the center. Insert the screw and tighten (but not fully). Then move and follow this order. Bottom to top left to right and back down. Locate the opposite screw hole until it is good, then tighten securely. I have an example circuit that I followed, but that's for the main screws. Do the same for the 22 small screws.