Header banner
Revain logoHome Page
Amanda Castillo photo
1 Level
9663 Review
6303 Karma

Review on πŸ–ŠοΈ Synthetic Pen Bushings - Set of 12 Non-Stick White Pen Bushings for Durable CA Finishing and Pen Turning by Amanda Castillo

Revainrating 1 out of 5

The diameter is too big.

The diameter is too large for the standard grip sleeve mandrel. This causes the workpiece to wobble (severely) as it rotates on the lathe, making coating very difficult, if not impossible.

Pros
  • SIZE TO FIT: These durable non-stick grip sleeves measure approximately 0.55" wide x 0.43" high, pre-drilled for a standard 7mm pen shaft, 60 degree taper, fits most pen sleeve sizes; Manual measurement, please allow a little error in size
Cons
  • old

Comments (1)

Please, sign in to write a comment
January 25, 2023
Don't waste your money. I feel it was a totoal waste of time.