Header banner
Revain logoHome Page
Jeff Payne photo
1 Level
1294 Review
51 Karma

Review on ๐Ÿ–จ๏ธ ELEGOO ANYCUBIC Printer: Revolutionary 0.15mm Thickness for Unparalleled Precision by Jeff Payne

Revainrating 5 out of 5

Not for Anycubic Photon Mono

later So obviously something is wrong with the instructions as they don't tell you to separate two layers of film or even two layers. Which one? I followed the instructions, the frame cracked and the print failed. After we removed the resin from the bottom of the cat, we could see the second layer of plastic as it broke. (Official website replacements come with framed film I believe. Just ordered a kit.) The film also doesn't fit Photon Mono and I had to cut it. The vat ended up leaking too because the seal was bad. Probably because the foil was too thick. I recommend buying a metal canister with a metal O-ring.

Pros
  • Hands-free operation
Cons
  • I'll write