Review on 🚗 Enhance Vehicle Stability with Moog K80002 Cam Bolt Kit by Jeff Pettis

I also have a ZX3 03 with excessive rear camber. After getting a set of Moog plates I decided not to use 1/2* and 1* plates on each wheel. Why? Because Moog doesn't actually recommend it. The instructions say to use 1/2* or 1* stakes. These plates are used to create a "side load" on the heads of the bolts that hold the car's rear axle. Maybe 1.5* is too much? Anyway, they were pretty easy to install. I didn't use rivets. I attached the RTV plates over the old rivets. (4) Screws hold everything in place. I also added a "rubber donut" to each coil spring. This raises the suspension a bit (helps with spring sag), stiffens the spring, and can reduce camber by about 1/2* or so. They also reduce the car's "roll" in corners, which leads to more tire wear. Note: You will not receive 8 screws. 4 only. You reuse 2 originals on each wheel.