I've used this for probably less than 200 hours printing at 230C for PETG and the first of the three has already stopped heat. It's not too expensive to replace, but it's the time it takes to replace any of them. Working with a wire loom is a pain. If you buy this make sure you don't connect it to the rest of the wires so if it burns out it will take 5 minutes to replace instead of an hour. The cable gets very hot, so take that into account when placing it and you'll hear the fan shroud cooling your parts. The printed PETG fan shroud will deform over time from contact with wires, and because it's so thick it's hard not to hit it.
NEMA 17 Stepper Motor With Built-In 400Mm T8 Lead Screw For Improved RepRap Prusa I3 3D Printer Z Axis Or CNC Machine Performance - Iverntech
9 Review
Pack Of 5 TMC2208 Stepper Motor Drivers For 3D Printers, DORHEA V1.2 Module With Heat Sink And Screwdriver For RepRap, RAMPS1.4, MKS, Prusa I3, Ender-3 Pro Controller Boards
19 Review
BIGTREETECH SKR Mini E3 V3.0 Control Board + TFT35 E3 V3.0.1 Graphic Smart Display Panel Board New Upgrade 3D Printer Parts For Ender 3, Ender3 Pro, Ender 3 V2
13 Review
BIGTREETECH TFT35 V3.0.1 Graphic Smart Display Controller Board For 3D Printer Ramps 1.4 RepRap 3D Printer Can Select Two Work Modes
13 Review
Flashforge Adventurer 3D Printer with Detachable Precision Leveling System
6 Review
🖨️ FLASHFORGE Adventurer: Enhanced 3D Printer with Removable Extruders and Monitoring Features
4 Review
🔵 IFUN 3D Rapid Resin - Low Odor Photopolymer Resin for 405nm LCD 3D Printer - Fast Curing, Standard Rigid Formula - Sky Blue, 500g
5 Review
🖨️ ANYCUBIC Assembled Innovation Off Line Printing: Streamline Your Printing Process with Cutting-Edge Technology
5 Review