Review on 🪚 Dastool Dt1903 Dust Collector Attachment: Effective Cutting Dust Shroud for Angle Grinder 4-1/2 inch to 5 inch by Dave Sapp

It works! A few minutes to figure out which adapter ring my 4.5" Milwaukee angle grinder used, add the included spacer to bring the blade closer to the center of the commutator, then adjust your shop vacuum to match and cut She! I cut floor tiles to clear a path for wall soles for a new pantry and my wife has made it very clear that she doesn't want to dust the house in every nook and cranny. Although some dust does go away, it's tiny and over 95-98% ends up in my HEPA bagged vacuum shop!* As can be seen from the photos, my Milwaukee 4.5" angle grinder took the red gasket with the flange with it .You want to make sure the sheath is in place and tightened well or it will fall out when you cut and it will be a big mess!*Don't forget the spacer provided to keep the blade more centered.Just note that I at mine had to take out the small bronze disc that came with my diamond blade as this caused the blade to spin freely, just make sure the blade is wedged firmly between the support/spacer assembly and the wrench. Full contact with the ground!When that tiny amount of dust seeps out, it doesn't come out of a round hole with on the side (leave it open for the air intake to get the necessary to generate airflow) and at the bottom if you tilt it and thus the depth flange will not be flat with the floor! Overall this was a great purchase and I would highly recommend it. It works!