Review on ANTCLABS BLTouch Leveling Premium Extension Additive Manufacturing Products by Roger King

So I've heard over and over again that this product is great for the Ender 3. I have everything to get it working on the Ender 3 (LCD adapters, longer cables, etc.). However, most of the tutorials did not have identical wires. Yellow/Red/Black in training. Yellow/Red Orange/Brown were mine. The LCD adapter just flickered. The connector part of the wires fell off. I had to remove the circuit board from the case to use the bltach with standard wires. Stock Board-> Dropped the Lcd Adapter once. I connected it to the board and when I turned it on the hand clip would light up. Like a match. Then there was just a bsod. 2. Board-> After many hours of firmware, the board gave up the ghost. The printer was alive, but there was no bltach? The new board had a straight connector for bltouch wires. However, the board refused to cooperate with the bltach. It will check if it's in settings, but it won't automatically align or find Z. After switching to resin printing, I moved away from FDM. I am currently starting to work on Ender3. And caused the same problem. It must be fake, I barely touched the board and it shorted out the same ARM chip? There are other online sellers or Revain that offer a better product because it is NOT BLTOUCH. I'm missing two boards for a piece of plastic. It shouldn't be that hard. I was playing around with Raspberry Pis