Review on 🔌 Arlington LV1 10 Voltage Mounting Bracket: Easy & Secure Installation by Jordan Rini

Amazing quality What makes these amazing: A.) Quality boxes. B.) are suitable for drywall and the hole cut may be small. about an inch and you can slide them in place for a nice fit. C.) is suitable for wood wall panels, but you will need to create a pilot hole with a 1-1/2 inch putty knife. and then cut out the rest of the hole. what you need to complete this setup.) Tape measureii.) Small spirit leveliii.) Hacksaw (I used http://www.amazon.com/Stanley-15-556-Jab -Cushion-Grip/dp/B00002X21W/)vi . ) you may need a spatula to start cutting with a hacksaw if installing in wood panels etc. How to: 1.) Use a reference measurement either from a corner of the wall or from an electrical outlet 2.) Use a Magnet or rod finder, place anywhere between two rods 3.) Find where to make a hole, top of the Arlington should be the same distance from the floor as other boxes on any other wall in the house. To find out without removing the faceplate of another unit, place the faceplate on the Arlington and measure from the top of another box on the wall in the room to the top of the Arlington with the faceplate. Mark on the wall where the top of Arlington will be. or where the top of the bezel is, and then subtract the top of the distance from the bezel to Arlington. facing the wall, level with the spirit level and at the height required for step 3.5.) Trace the inside opening of the Arlington with a pencil or ballpoint pen (I suggest a pencil so you can erase the marks if you make a mistake is made). 6 .) Using a spirit level, ensure the lines form a perfect square/rectangle. 7.) Using a hacksaw, make a cut along the outside edge of the lines you just circled. 8.) Insert the Arlington into the hole you just cut the hole if your reference measurements between ground floor and attic are accurate. 9.A.) For push rod I used: Cen-Tech 65327 3/16" x 11' Fiberglass Wire Guide Set 9.B.) For bungee cord I used: Greenlee 430-500 Poly Fish Line, Tracer Green, 500- Foot 9.C.) For Cat6 I used: [[ASIN:B005UFKJPG Cat6, 550MHz, UTP, 23AWG, 8C Solid Pure Copper, CMR, 1000ft, White, Bulk Ethernet10.) Pull through the wire you attached to the Wall hang, insert the arlington and screw, but don't over tighten 11.) Connect the connectors to the wire and install the faceplates.