Review on 💠 C275B-QWD168 Sceptre 165Hz Curved DisplayPort Monitor with 2560x1440 Resolution, Adjustable Tilt, Built-in Speakers and Frameless Design by David Ross

The display is excellent, no dead pixels. But at the cost of 10 hours of my time. I connected it with the supplied DP cable and everything was fine. Then I made a backup 3 days later. Then Scepter 24" wouldn't play. The other 3 monitors (3840x2160, 1920x1200, 1920x1080) seemed to work. I downloaded Evernote replacement programs and thought I had found a bug causing my monitors not to work Worked Only 3840 and 1920 x 1200 connect Another monitor showed up but failed to connect Scepter didn't show up in settings Tried to remove/reconnect the transducer but not the scepter I restored a previous backup , after losing 40 calls in the last 4 days (I'm a radio amateur) no files .Tried to change cables on the back of the PC (lots of switches. No change, no scepter. Must be a monitor or DP cable. Hooked it up to the HDMI port on the back of the monitor and it worked (hours) I will keep it for 3 weeks and see if it fares there are problems. I can use it with an HDMI port. Buy it again. No way. If I knew it was a DP port it would be a 5 minute swap I have two Zepter TVs (50" and 55") that have been working fine for over 3 years.2021-07-28 Two further problems.1. Cannot change the brightness. This is displayed on the screen but I can't change it.2. Screen cannot be printed. When using FastStone Capture, the entire Scepter screen becomes bright white (no characters/no photos). Too many problems, I will return it.