Review on 12X9X3 Inch Granite Surface Plate With No Ledge - Perfect For Precision Measurement by Rahman Lassiter
It's definitely flat
I'll admit, I was a bit concerned at first. I laid my straight edge across the surface and could see light shining through underneath. However, I used my smallest feeler gauge (0.015" / 0.04mm) and couldn't slide it under the straight edge anywhere.Is it flat within .0025mm as they claim? Probably not. It's definitely better than 0.04mm though and that's perfect for my needs.
- For General Inspection Work Throughout The Shop
- This surface plate may require additional accessories like clamps, gauges, and indicators to be properly used, which can be an added expense
New products
Comments (0)
Top products in 📏 Calibration
Enhanced Performance: Fluke BP190 Rechargeable Capacity ScopeMeter - Revolutionizing Test and Measurement Efficiency
5 Review
📏 Accurate Truweigh Calibration Weight Precision 6 Piece Set: For Precise Measurements
5 Review
💡 Enhanced Fluke T6-600 Electrical Tester: Boosting Efficiency and Accuracy
4 Review
📏 BONATE Scale Balancing Calibration Weight
4 Review
Another interesting products
🔥 Advanced Testo Wireless Hot Wire Anemometer Technology
4 Review
🔍 Dioxide Controller for Digital Gas Monitoring
5 Review
🌬️ Advanced 3-in-1 Indoor Air Quality Monitor with CO2/RH/Temp Data Logging and Audible Alarm - NDIR Sensor Technology
8 Review
Portable Handheld Manometer 📏 for Accurate Pressure Differential Measurement
5 Review