The light isn't very bright, but it adds just the right amount of light. They're tricky to install (if you get it right) and there's one thing you need to remember: black is ground, and black with a white stripe is positive. To tell you about my setup, I put the headlights through the small holes under the rail. Who hid all the cables? I routed the wiring through the two rear square holes (mounting area) on the bed. Mine has covers. This is where I kept the switch. I then routed all the wires where my 7 pin connector connects under the truck. I pulled out my 7 pin and connected it to the 12 volt red/black wire. I also added a built in 20 amp fuse for safety. Plug one side and power into the square hole where my switch is and complete the circuit. The right and left lights are connected with one wire, and the power supply is connected with the other. See photos for questions.
Heavy Duty Wheel Arch Roller Flaring Former For Automobile Maintenance - Goplus Fender Roller Reforming Tool (Blue)
14 Review
Nissan Brake Control Wiring Adapter: Tekonsha 3050-P - Enhanced for Seamless Integration
10 Review
🚚 MAXXHAUL 70094 12V Trailer Light Kit: Ultimate Lighting Solution for Trailers Under 80
10 Review
🧲 MUTUACTOR 2Pack 100lb Anti-Scratch Neodymium Rubber Coated Magnet: Versatile Magnetic Base for Off-Road Vehicle Lighting, LED Working/Signal Lights, Antenna, and More!
17 Review
Get Ultimate Towing Stability With CURT TruTrack Weight Distribution Hitch & Sway Control - Up To 10K Capacity, 2-Inch Shank & 2-5/16-Inch Ball - In Sleek Black Design
30 Review
Yokohama Ice Guard IG50 215/50 R17 99Q winter
36 Review
4WD ORCISH Recovery Traction Boards Tracks Tire Ladder For Sand Snow Mud - Set Of 2 (2Nd Gen Bag + Mounting Pins, Black)
39 Review
SuperJump Trampoline with SuperJump 8ft (244 cm) net and ladder
29 Review