Review on Creality 3D 235X235Mm Removable Replacement by Gary Shakeone

UPDATE: The seller fixed this issue very quickly and the bed is truly phenomenal. Do not heat the bed when cleaning with alcohol! Use only a small amount of 91% IPA (95% is recommended but I can't find that concentration) and it should evaporate quickly without heating. , I want to say that this printable surface is phenomenal straight away. I'm not 100% sure why, however, but the PEI coating created these little bubbles after just a few days of use and maintenance. It's hard to tell from the attached photo because they are very small, but they are there. I can only imagine they only get worse over time... I may have used isopropyl alcohol to clean the surface when the bed was slightly warm. As a result, it evaporates quickly, leaving a clean surface. I try to do this every few prints and have been doing so for a long time. I have never experienced this problem before and the item description states that the IPA is safe to use on the surface. doesn't really help with liability...