Header banner
Revain logoHome Page
Hunter Schneider photo
1 Level
845 Review
54 Karma

Review on 🌑️ Enhance Engine Performance with Standard Motor Products TX195 Coolant Temperature Sensor by Hunter Schneider

Revainrating 5 out of 5

2012 Jeep Wangler JK

You will need to go through the fender to easily access this sensor. Slide the red latch back, press and release. Use a 3/4" socket to remove and install and you're done. Note. I did a coolant flush and thermostat replacement at the same time as replacing the sensor and there were air bubbles in my cooling system. Be sure to purge air from the system as your car will give out codes that would lead you to believe this sensor is faulty. After blowing off all the air and clearing the codes everything was perfect and working as it should again.

Pros
  • Best
Cons
  • Slightly Torn