Review on 📺 PERLESMITH Swivel TV Stand: Height Adjustable Table Top Base for 32-70 inch 4K Flat Screen TVs - VESA 600x400mm by Stacy Johnson

There are many similar looking products at Revain. I chose this one because it was one of the few that turned and it was the only one I saw with a ROPS seat belt. This is more important than you probably think. They have a lot of weight at a height that can tip over. This can be caused by a child, cats chasing wildly through the house, or even an adult accidentally hitting the TV while vacuuming or something similar. If it falls, you've destroyed expensive electronics and could easily injure or kill a child or pet. For this reason, I consider a rollover protection belt to be essential. As for the basics, it was easy to assemble even for me, who is utterly inept (although some points could be made clearer in the instructions). It seems to be as durable as I could have expected; it doesn't look weighed down by the 65" TV I have installed on it. And that's why this large screen fits easily in my 35" TV case. It also elevates the clock face above my soundbar so no part of the screen is blocked. This does not interfere with access to all ports/jacks/jacks from the back. Turning is easy. I have no problem with it moving too easily or falling off when flipped as another reviewer mentioned. I find, this thing is a hell of a near perfect solution to the tv mount issue I'm having. Very satisfied. EDITED TO ADD: I see another reviewer said their TV is crooked. I see how that can happen .When I attached the horizontal supports I noticed that they were not aligned.I have found that there is a slight play or play in how they fit on the main vertical support.I untied the screws and adjusted them with a ruler to make sure the ends of the two horizontal pieces were the same distance from the floor, and then tightened the screws. This resolved the issue and my TV sat perfectly on top of the finished product. But this is something you need to keep in mind; If you only notice this after the TV is installed, you will need to disassemble, align, and then reassemble everything related to this assembly step.