The unit is easy to use but there is a catch, I made some frames for some photos, the wood itself was about 1/ 2 inch thick of this unit is about 1 inch so when the frame is on the table ready to glue do not just lay this unit on the corners and tighten because the corners will not center in the plastic. the corner pieces, it will look great from your point of view, but it pushes the corners under the frame where the table is. When the glue has set the top will be perfect, but if you turn the frame over you can see the gaps created because the print was on the top of the frame and not enough underneath (where it was on the table). I would recommend the factory to make the same device with a thinner nylon strip and plastic corners. So you can place it in the middle of the wood to be glued.
Multitool pliers LEATHERMAN Wave plus (832524/832526) black
17 Review
MAXPOWER Piece 3-4-6 Inch
11 Review
WETOLS Angle Clamp 2Pcs Woodworking: Precision Tool for Perfect Angles in Woodworking Projects
11 Review
TOFL Woodworking Clamping Cabinets: 🪚 The Ultimate Storage Solution for Workshop Positioning
12 Review