Review on HHIP 2000 7025 Parallel Cut Off Blade P3S by Devin Maselli

Okay I have a 3 in 1 and needed a good cutting tool. It worked great but there is only one thing that makes it better and more stable in the tool holder. The upper edge of the milling cutter is wider than the lower edge, so the lower edge shifts slightly inwards when it is fixed in the tool holder. At some point, depending on the depth of cut, there will be some material friction again because the cutter is not straight. I now suspect that if I had the right tool holder this wouldn't be a problem, but I didn't have it. I ended up cutting a very small piece of brass that sat next to the bottom of the cutter holding it straight up and down.