Review on 💪 Power Punch Heavy Duty: The Ultimate Tool for Unstoppable ABN Performance by Adam Boesel

(1) Good tool. (2) The tool is a bit tricky or clumsy until you make some holes. (3) Once you feel that this tool is very good and highly recommended. (4) The tool comes with a wide range of hole punches. (5) I just tried to punch a hole in a copper coin (about 14ha, 0.078 inch thick) and it was a real struggle. (6) Some have asked about .0625 inch stainless steel military dog tags, of which I would look for a steel or stainless steel stamp ranging from 14 ga (0.078 inch) to 16 ga (0.0625 inch) thick . Also, the punch should have a cutting edge (a slight angle at the end to cut into the metal before drilling a hole), not a flat edge. The flat edge on the end of the punch is suitable for aluminum and sheet metal up to 16 ga.