Review on Winjet Fog Lights Set for 🚙 [2016-2019 Nissan Titan] with Switch & Wiring Kit by Mark Repp

So I got the fog lights with fast delivery. After reading some reviews, I decided to buy a factory switch installed in the cabin. I haven't even tried the included switch, but it looks like it will work. When installing the factory switch, loosen the two Phillips screws on the underside of the bezel and pull the bezel toward you. You will then find two more Phillips head screws for the row of switches and remove them. You can then use a screwdriver to pry out the blank factory switch. You'll also find a pre-wired Molex connector for the switch. Simply insert a new switch and plug it in. Install two screws to secure the switch bank, then close the panel and you are done installing the switch. You can then push out the connector on the front bumper. On the driver's side facing the truck, pull out the front left side of the insert, and then pull the insert out to the left. If you look at the new fog lights, you'll see why you have to pull to the left to remove the connector. Then under the truck you have two Phillips head screws that need to be removed to allow the fairing to give you more room. Headlights enter under the bumper and from behind. There are already pre-assembled plugs on both sides. Then do the same for the passenger side. The time it took me to figure it out and complete it without instructions was about 1.5 hours. Really a piece of the pie.