Halfway through the project I realized I was going to need clips. Those were the ones I could get the quickest. After reading the reviews I pulled the clutch on my drill a bit and they all went in with no problem. I see screws go bad if you hit them with a 20v drill. If that bothers you, you can just replace them with the ones you buy at hardware stores, which each seem to have a box. Will definitely order again.
Protective And Stylish: XCEL 4Ft W X 5Ft H Black Steel Fence Gate With Anti-Rust Technology And Sharp End Pickets For Effortless Installation And Durable Outdoor Use
34 Review
Non-Slip Brown Carpet Stair Treads - 15-Pack Of 8"X30" Runners For Wooden Steps
39 Review
RF Remote Control Switch EMylo Smart Wireless Relay AC 110-240V 2000W 1 Channel Momentary 433MHz Module With 2 Transmitters
40 Review
Easy Install White Magnetic Door Screen For Doorways And Sliding Doors - Fits 34X82 Fiberglass Mesh Screen With Heavy Duty Magnets - Screen Size 36X83
36 Review
🔥 MH40NG Mr. Heater F272800 40,000 BTU Multi Natural Gas Garage Heater
26 Review
Seal And Insulate Your Doors And Windows With TamBee Self-Adhesive Weatherstrips - 65.6 Ft Black Roll
38 Review
High-Performance Convection Heater By Mr. Heater Corp, Ranging From 75K To 200 BTU/HR
47 Review
White Self-Adhesive Tape For Weatherproofing Doors And Windows - 16Ft X 1.77In (45Mm) - Includes Weather Stripping And Silicone Seal Strip For Draft Stopping And Shower Glass Protection
27 Review