Review on 🔧 Coceca 458pcs Sanding Drums and Sleeves Kit for Drum Sander with 24pcs Drum Mandrels and 2pcs Self-Tightening Drill Chuck by Jeremy Kakaruk

Good news: the sockets fit and work well with a Dremel 4300 flex shaft (I have one). All of the mandrels included in the kit fit both types of collets I have and the sanding drums themselves are of decent quality. For every 10 kegs in the package there were only 1 or 2 defective ones. For such a large package, I would call it acceptable. The bad news: sanding drums will NOT fit the Dremel brand mandrels. That would be fine, except the mandrels that come with this set have a beveled end that fits in a dremel drill bit. This worries me for obvious reasons. I was able to find a single spike that was less inclined than the others and I have used it successfully. However, worried about using a slanted bottom mandrel, so I'll look for another solution. Bottom line: I personally wouldn't buy them again due to the crooked mandrels and the fact that the drums themselves don't work with the Dremel brand. If the drums fit Dremel mandrels (which are all flat) I'd say this pack is worth the money. But since the drums don't fit, leaving slanting mandrels as the only use for these drums, I don't think it's a good buy. BUT, if you're comfortable with slanted spikes and just want drums, I'd say this is a great buy! You get many different spreader drums and most of them are error free. Like I said, I have mixed feelings about this set. It might be a good buy, but if you're looking for drums that mount on a Dremel mandrel, this set probably won't work for you.