I replaced the vertical trim on the rear of my rv. At the roof about 4 inches of that trim is bent over the roof. BE SURE TO HAVE YOUR SCREW COVER INSERT IN PLACE BEFORE/WHILE BENDING THE ALIMINUM TRIM. ONCE BENT TO THE REQUIRED ANGLE PULL THE INSERT BACK TO (NOT PAST) THE CORNER, FINAL SCREW, REPLACE LAST OF INSERT. I realized I screwed up as I bent the trim around the corner and watched the insert groves close. I was able to trim the insert at the corner to make it fit. not a full fail as the insert is not intended to be a water seal and I put some clear sealant over the error, but if details mater to you.Also the predrilled holes did not match the factory holes so I had to thicken some epoxy epoxy fill the original screw holes in rv paneling. Not a big deal.
EternaBond Mobile Sealant Repair Authentic
9 Review
🦍 Gorilla 101895 Waterproof Patch & Seal Tape, 1-Pack: White, Reliable & Effective Solution
10 Review
🔒 Protective 4" Square Rubber Bumper Plug End Cap Cover for RVs, Campers & Trailers - Pack of 2
9 Review
XFasten RV Repair Tape, White, 4-Inches By 50-Foot, Weatherproof RV Rubber Roof Patch Tape For RV Repair, Window, Vent, Boat Sealing, And Camper Roof Leaks
23 Review
12V DC Electric Trailer Jack - 2000Lb Lift Capacity With Hard-Wire Connection
12 Review
RV Outdoor Mat: LATCH.IT 5X8 Boho Style Reversible Rug Ideal For Camping & Camper Use – The Ultimate RV Patio Rug For All Occasions!
30 Review
🚪 Upgraded RV Screen Door Slider Panel with Easy-Push Knob Opener
10 Review
Lippert Solid Stance RV Step Stabilizer Kit For 5Th Wheels, Travel Trailers And Motorhomes
20 Review