Review on Atwood 91447 Heater Thermostat Assembly by Quintin Gore
Warning, replacing the sensors is very difficult
Externally, replacing temperature sensors looks very simple. Well it isn't. Try sliding the small clear plastic yoke under the three tabs on the water heater and turning while the spring pushes on the yoke. Maybe there's a trick I'd like to post. After finally installing them an hour later, I thought maybe a bit of silicone spray on the studs would have helped. I do not know.
- Stylish and modern design
- Very expensive
New products
Comments (0)
Top products in π° RV Plumbing Parts
Another interesting products
Keep Your RV Clean And Safe With LATCH.IT RV Step Covers - 3 Pack, 22" Wide, Best Fits 8-11" Deep RV Stairs - Protect Your Radius Steps Today!
21 Review
Protect Your RV With LATCH.IT Shade: 7'X9' Zippered Screen Awning For Ultimate Wind Protection And Privacy.
15 Review
12V DC Electric Trailer Jack - 2000Lb Lift Capacity With Hard-Wire Connection
12 Review
πͺ Upgraded RV Screen Door Slider Panel with Easy-Push Knob Opener
10 Review